It is designed to withstand pressures up to 30 Bar (290 msw / 950 fsw). The pressure sensor that is used to determine depth is rated by the manufactured to be calibrated to a pressure of 14 Bar (about 130 msw / 425 fsw). The depth sensor will continue to function to this depth, however, at reduced accuracy. However, the case is rated to withstand 260 msw / 850 fsw. Summary: The guaranteed depth accuracy range is to 130 msw / 425 fsw. This means the auto-on occurs at about 3 m (10 ft) underwater when at an altitude of 2000 m. Therefore, at this altitude the Perdix must be submerged underwater by 300 mbar to reach an absolute pressure of 1100 mbar. For example, when at 2000 m (6500 ft) altitude the atmospheric pressure is only about 800 mbar. If at higher altitude, then the Perdix auto-on will occur at a deeper depth. So the Perdix will automatically turn-on when about 0.9 m (3 ft) underwater when at sea level. For reference, normal sea level pressure is 1013 mbar and 1 mbar of pressure corresponds to approximately 1 cm (0.4") of water. It can take up to 15 seconds for the Perdix to activate once 1100 mbar is exceeded.
![macdive error code 7 macdive error code 7](https://i.imgur.com/HTH9Lk0.jpg)
The Perdix turns on automatically when the absolute pressure is greater than 1100 millibar (mbar). We recommend turning on manually before each dive to confirm proper operation and to double check battery status and setup. This feature is supplied as a backup for when you forget to turn on your Perdix. This is based on pressure increase and not on the presence of water (i.e. The Perdix will automatically turn-on when submerged underwater. excessive force may cause damage to the PET screen protector.ĭoes the Perdix have wet contacts? \ Will the Perdix turn-on automatically? Repeated removal of the PET screen protector may cause it to lose its adhesiveness. the section is not adhering, and you will need to gently peel off the screen protector carefully and reinstall it. Air bubbles will automatically disappear within 24 hours.
#Macdive error code 7 free
![macdive error code 7 macdive error code 7](https://www.errorlive.com/wp-content/uploads/2016/09/Windows-error-code-0x80070426-1024x365.jpg)
Press the center of the PET screen protector and remove the tiny air bubbles by gently pushing outwards with the squeegee from the center (Allow 1 - 2 days for the smaller bubbles to fully disappear).Peel off the protective film from the PET screen protector.Clean the dust on the screen with the dust absorber sticker.then clear the remaining liquid with the microfiber cloth. Clean the screen of your Teric with wet wipes followed by the dry wipes.
![macdive error code 7 macdive error code 7](https://cdn.windowsreport.com/wp-content/uploads/2017/01/video-card2.png)
pre-position the screen protector to the Teric (adhesive side downward).
#Macdive error code 7 how to
How to apply a Teric PET Screen Protector